A307 All Thread Rod, Plated
A307 All Thread Rod, Plated
Manufacturers:
The ASTM A307 specification covers carbon steel bolts and studs ranging from 1/4" through 4" diameter. A307 is an economical low carbon material often manufactured using A36 round bar. Dimensional specifications are governed by ASME B18.31.3. A307 all thread rod is available in zinc plated finish. Zinc plating sacrifices itself, corroding before the base material, offering added corrosion resistance. The all thread rod listed on this page is domestic where specified, melted and manufactured in the USA.
Products
Governing Standards
| ASTM A307 | Covers the mechanical and material requirements for inch series fasteners in diameters from 1/4″ through 4″, made of carbon steel having a minimum tensile strength of 60,000 psi. |
| ASME B18.31.3 | Covers the general and dimensional data for inch series threaded rods. |
| ASME B1.1 UNC & UNF Class 2A | Specifies the thread form, series, class, allowance, tolerance, and designation for unified screw threads. |
Chemical Properties
| Per ASTM A307-2014 | |||
| Carbon | Manganese | Phosphorus | Sulfur |
| % by heat analysis |
% by heat analysis |
% by heat analysis |
% by heat analysis |
| 0.29 | 1.20 | 0.04 | 0.15 |
Mechanical Properties
| Low Carbon Steel | Per ASTM A307-2014 | |||
| Diameter | Bolt or Stud Length | Tensile Strength |
Elongation | Core Hardness (1) |
| Min psi | Min % | Rockwell | ||
| 1/4 thru 4" | Less than 3 X dia (2) | 60,000 | 18 | B69 to B100 |
| 3 X dia and longer | 60,000 | 18 | B100 | |
- 1. As measured anywhere on the surface or through the cross section.
- 2. Also bolts with drilled or undersized heads. These sizes and bolts with modified heads shall meet the minimum and maximum hardness as hardness is the only requirement.