How do you use a screw extractor to remove a broken bolt?
To remove a broken bolt with a screw extractor, drill a centered pilot hole in the bolt, seat a spiral flute extractor in the hole, and turn it counterclockwise. The extractor has a left hand spiral, so it wedges tighter as it turns and backs the bolt out of the threads.
Spiral flute screw extractors work on broken bolts, studs, and cap screws that sheared below the surface. They are a common fix on flange bolts, pump housings, and equipment covers where the threads are still good.
Step by Step Extraction
- Soak the bolt with penetrating oil and let it work.
- File or grind the broken face flat if it is jagged.
- Center punch the exact center of the bolt.
- Drill a pilot hole with the drill size listed for the extractor.
- Drill at least as deep as the bolt diameter.
- Tap the extractor into the hole with a light hammer blow.
- Turn it counterclockwise with a tap wrench using slow, steady force.
A left hand drill bit for the pilot hole sometimes catches and spins the bolt out before the extractor is needed.
Choose the extractor by bolt diameter. Most extractor sets list the bolt size range and pilot drill for each extractor number, so use that table instead of guessing. An extractor that is too small for the bolt is more likely to twist off. A pilot hole that is too large thins the bolt wall and can split it.
Avoid Breaking the Extractor
Screw extractors are hardened and brittle. Jerky force or a wrench that side loads the tool can snap it in the hole. A broken extractor is harder than the bolt and very hard to drill out. Keep the wrench square, use a tap wrench instead of a long breaker bar, and stop to apply more oil or heat if the bolt will not move.
If the Bolt Will Not Come Out
Heat the surrounding metal to expand it and break corrosion or threadlocker. Off center or stripped pilot holes call for the next extractor size up. If the bolt still will not turn, drill it out close to the minor diameter and chase the threads with a tap. If the threads are damaged, install a threaded repair insert.
STS Industrial Bolt Removal Supply
STS Industrial stocks Spiral Flute Screw Extractors, Thread Repair Coil Inserts and kits, and E-Z Lock Threaded Inserts for Metal in its bolt removal and thread repair line. Pair extractors with cobalt and HSS drill bits for pilot holes. Browse all cutting tools.
Stuck with a broken bolt on equipment? Contact STS Industrial or call (855) 416-2658 to get the right extractor size.
